Title: BNO055 Not Detected by degz-suibo

Aliyev Emil

I'm using the BNO055 IMU sensor with the degz-suibo library on Degz Suibo, but it seems like the library can't find or detect the sensor. I’ve connected it using I2C (SDA/SCL on Suibo: 2/3), and I’m sure the wiring is correct.
I also tried scanning the I2C bus, and it doesn’t seem to return the BNO055 address.

veli çoşanay

hi, on the suibo the sda and scl pins are in the second column from the left on the bottom side when the board is held upright. can you try again and the share the result? and dont forget the check the wiki page
https://wiki.degzrobotics.com/elektronik-kartlar/Kontrol-Kartlar%C4%B1/suibo-rp2040/

Aliyev Emil

Heyy, I connected the sda and scl pins, but what should I write in the code, so it can find it, I mean bus adress or smth

veli çoşanay

you can use adafruit bno055 library. there are examples in the repository.
adafruit/Adafruit_BNO055

Aliyev Emil

I'm using adafruit_bno055 library since day 1, it's not for suibo I guess